义乌市周萱电子商务商行

X006使用说明书 该产品支持GSM850/900/1800/1900网络和GPRS,标准四频,并且可以在不同网络间无缝切换.体积小巧;信号强;声音大;定位精准;性能稳定;超长待机;全球通用.这些功能是它最大的优势. 开 机：打开后盖,将手机卡插进卡座即自动开机，待指示灯熄灭后即可使用 监控侦测:开机正常后,在需要的时候用能拨打的工具进行监控,拨打接通后即可听到该周围所处位置10米内的状况 声控回拨：?电话开启：用固话或手机拔打报警器里的SIM卡号，打通后立刻挂掉即设定成功，默认报警状态。（当报警器4米内有35分贝的声音时，报警器就会自动拨打所设定的号码）?短信开启：编辑短信"KQSK"发送至报警器.（当报警器4米内有35分贝的声音时，报警器就会自动拨打所设定的号码）人工调节灵敏度：用户编辑短信"KQSK#30#"发送至报警器."KQSK"后面的数字"30"是声音检测的灵敏度数值.可以为20(灵敏度高)-500(灵敏度低) 震动回拨：编辑短信"KQZD"发送至报警器.（当报警器受到外部震动时，就会自动拨打所设定的号码。） 备注:电话开启、短信开启和振动回拨三种功能不能同时操作,它们之间的切换需先发CLOSE指令关闭正在进行的某一项,再执行其他的操作,三种功能的关闭操作均为编辑短信"CLOSE"发送至报警器 电量查询指令：发“power”指令，如用户编辑短信“power”至报警器，报警器会检测电量并根据电量不同会回传以下的短信内容： “Tracker battery full”(表示该机电量满) “Tracker battery half”(表示该机电量中等) “Tracker battery low”(表示该机电量低，应及时充电)” 充 电:为了增加报警器使用时间，延长电池寿命，降低待机电流，给报警器充电时必须插入手机卡才能正常充电 注意事项： *新机使用前要充满电，以达到最佳效果，请使用原机配带的充电线 *充电器标配：±5．0V 300-500MA，以免损坏主机 *灯不亮，电池没电，充电后再使用 *打不通电话，重新插卡开机或充电后再测试 *不自动接听，重新插卡开机 *需外加控制器，要自行定做 *请勿自行拆机，人为造成的损坏不在“三包”范围 X006 manual The product supports the a the GSM850/900/1800/1900 network and GPRS standard quad-band, and can switch seamlessly between different networks. Compact; signal strength; voice; precise positioning; stable performance; the long standby; globally.function is its greatest advantage. Power on: Open the back cover, the SIM card inserted into the card holder automatically boot until the indicator goes off, you can use Monitoring to detect: normal boot, when necessary monitoring tools can dial the dial is turned to hear the status of the location around 10 meters Voice Callback: To unlock the phone: dial the SIM card number in the alarm, with fixed-line or mobile phone to get through immediately hang up after that setup is successful, the default alarm status.(35 decibels of sound when the alarm within 4 meters, the alarm will automatically dial the number set) SMS opens: edit SMS "KQSK" sent to the alarm (35 decibels of sound when the alarm within 4 meters, the alarm will automatically dial the number set) Manual sensitivity adjustment: user edit SMS "KQSK # 30 #" is sent to the alarm. "The KQSK behind the numbers" 30 "is the sound detection sensitivity value 20 (high sensitivity) -500 (low sensitivity) Shock callback: edit the text message " KQZD " to send alarm ( when the alarm is subjected to an external shock, will automatically dial the preset number. ) Note: to unlock the phone, SMS open and vibration callback functions three can operate at the same time, switching between them need to send "CLOSE "command to turn off the ongoing one, and perform other operations, with three functions of closing operation are editing short message " CLOSE " to send alarm Electricity the query instructions: hair "power" command, such as the user edit SMS "power" to the alarm, the alarm will detect electricity accordance with different power will return the following SMS: "Tracker battery full" (said the aircraft battery is full) "Tracker battery half" (aircraft power medium) "Tracker battery low" (the aircraft battery is low and should be promptly charged) Charge: the use of time in order to increase the alarm, extend battery life, reduce the standby current, charging the alarm must be inserted in the phone card to normal charge Note: * Before the use of the new machine is fully charged, in order to achieve the best results, use the original machine is equipped with a charging cable * Charger Standard: ± 5.0V 300-500MA, to avoid damage to the host * The lamp is not lit, the battery is dead, charge before use * Could not get through to re-boot card or charge after the test * Does not auto-answer, and re-boot card * Require an external controller, want their own custom-made * Do not attempt to disassemble, damage caused by man is not in the scope of the "three guarantees