Manual
First, the installation: first corn sheller and the engine installed in the holder, and then fitted with belt, elastic belt moderate. Fan mouth with debris bags (length 1200mm, breathable fabric to be good.)
Second, the adjustment: Adjust the gap according to the size of corn ears, Grate and the distance between the corn cob drum diameter.
Little← →big
Little big
Third, the use of: before starting the engine completely fed corn, feed corn moisture content according to the size of the decision, feeding a small amount of water is high, water is fed to a small volume.
Fourth, note:
1, the machine running when not in depth hands or other objects inside the machine.
2, machine operators should wear work clothes. Clothes to avoid dangerous spiral belt.
3, 100-200 hours of machine running add oil to a bearing.
4, clean the spindle wound debris into the bearing chamber to avoid the complex characteristics that affect the normal use of sintered bearings.
5, clean the corn and corn around the machine, not buried beneath the engine.
V. Troubleshooting:
Failure: from the net rate is not high solution: adjust the spindle and the Grate gap, dry off the net rate of 99% corn, wet corn off the net rate of 95%.
Fault: bearing room temperature solutions: cleaning bearings refueling or replacement.
Failure: the school rate is too low Solution: Adjust the belt tension, the spindle speed of 1,400 revolutions per minute.
Fault: corn seed crushing solution: spindle speed is too high, should reduce the engine throttle.
Six: The Maize corn sheller thresher for new, high efficiency ultra-clean characteristics. If you use the better seeItalyplease and we will make improvements based on your feedback, let me make progress together! Thank you!