你现在的位置:

35W导轨金卤灯灯具,电子镇流器,商场照明,佛山货源,室内照明成品

产品概述产品名称:35W电子镇流器+灯具产品型号:DR835A工作环境:室内使用,-25℃-50℃使用寿命:镇流器ge;30000小时质保期:镇

  • 产品单价: 118.00元/118.00元
  • 品牌名称:

  • 产地:

    安徽 合肥市

  • 产品类别:

    金卤灯

  • 有效期:

    长期有效

  •  
留言询价 加入收藏
该企业其他产品更多»
35W导轨金卤灯灯具,电子镇流器,商场照明,佛山货源,室内照明成品
¥118.00 709人浏览

35W导轨金卤灯灯具,电子镇流器

推荐
  • 产品详情
  • 网友评价

产品参数

起订: 50 118.00元 供货总量:
发货期限: 自买家付款之日起 天内发货 所在地: 安徽 合肥市
有效期至: 长期有效 品牌:

详情介绍

产品概述

产品名称:35W电子镇流器+灯具
产品型号:DR835A
工作环境:室内使用,-25℃-50℃
使用寿命:镇流器≥30000小时
质保期:镇流器两年
通过认证:CE,FCC,RoHS

 Product name: 35W Electronic ballast,
Product model: DR835A
Working environment: For indoor use, -25℃-50℃
Service life: ≥30000 hours
Warranty period: Two years for ballast and one year for lamps
Certificates: CE, FCC, RoHS

功能优势:
1. 宽电压输入范围:85Vac-265Vac
2. 综合节约能源35%(与电感镇流器相比)
3. 整个灯管寿命期间,流明维持系数>90%
4. 高效率、高功率因素(&gt;0.98),低谐波含量(<10%)。
5. 低频方波输出,避免音频共振,电网环境洁净。
6. 防电磁干扰,无频闪,无噪音,带舒适的照明效果。
7. 保护功能:过温、过载、空载保护
8. 最紧凑的尺寸, 轻便小巧。

Functional advantages:
1. Wide voltage input range: 85Vac-265Vac
2. Comprehensive energy-saving 35% (compared with electromagnetic ballast)
3. During the whole tube service life, lumen maintenance coefficient >90%
4. High-efficiency, high power factor (&gt;0.98), low harmonic content (&lt;10%)
5. Low-frequency square wave output, avoid audio resonance, clean grid environment
6. Electromagnetic interference resistant, no flash, no noise, with comfortable lighting effect
7. Protection function: over-temperature, overload, no-load protection
8. Most compact size, portable and small

技术参数

执行标准:
工作原理Working principle:EN60929
安全Safety:EN 61347
电磁兼容Electromagnetic compatibility:EN55015 & EN61000&61547
环保Environment protection:EPA3050B & EN1122 & EPA3052 & EPA3060A & EPA7196 & EPA3540C & EPA8270C

安装尺寸

特别注意
1. 在安装设备前,请仔细阅读说明书,严格按照安装示意图进行安装,否则会烧毁本品。
2. 接线之前一定要注意设备的工作电压和接线位置,以免烧坏设备
3. 为保证光源的最佳工作状态,本镇流器应与相应的灯管配套使用。
4. 本产品工作时输出端瞬间电压有可能达到3KV以上,在安装和更换灯管时必须切断电源!
5. 安装本产品时必须做好防雨,防潮,防湿措施,并安装于具有足够承受力的位置。

Special notice:
1. Please read manual carefully before equipment installation. Please install in strict
accordance with installation diagram. Otherwise, the product will be burned.
2. Please pay attention to the working voltage and wiring position before wiring, to avoid
burning out equipment
3. To ensure the best working status of light source, this ballast should be matched with
corresponding tube.
4. When this product is working, the instantaneous voltage of its output terminal may be up
to 3KV. The power must be cut during tube installation and change.
5. Please take certain steps on rain-proof, moisture-proof and damp-proof during product
installation. And please insure that this product should be installed in the position with
enough capacity.

35W电子镇流器(DR835A)-尺寸图

Dimensional Diagram


35W电子镇流器(DR835A)-安装示意图

Wiring Diagram

网友评价 0条 [查看全部]