华商宝

Normally, we put the coaster pager on recharger base, the recharge will stop automatically after recharge finished. You can give pager to guest when needed..
Attention: The power of transmitter is DC7.5-12V, Recharge base is DC5V, and it must be right used.

The using guide of transmitter:
Step 1: connect transmitter with power adapter, power led is on, standby screen will be shown.
Step 2 : input the call No., press SEND to send call.(If no text receiver, no need to input message, just call No. is enough.), If there are much strong noise signal, the transmitter will delay the sending till noise disappear. Press ESC can clear all the message and Call No. on screen.
The using of coaster pager.
Recharge status: After the recharge base connected to DC5V power, put the coaster pager on the base, The pager will be on recharge status, a led will be on shows the pager is on recharge status, if the led is off, that shows recharge finished.
Low battery indicator: When the battery is nearly using up, there are 2 led will be on near the nixie tube, and the nixie tube will display LO and pager No. alternately.(When the pager has others not only No. diplay,LO will not be display, just low bat led is on.)
ON/OFF pager: When pager is taken off the recharge base, it will be in working status after a short alert with sound, vibrate and flash. The pager will display No. intermittently. If in 10S, press button on the bottom case for more than 3S, the nixie tube will display OFF, All the alert leds will be on, shows the pager will be off immediately. If put the power off pager on recharge base and take it off again, the pager will be on automatically.
Working ways: When pager received call message in working status, it will alert 15S with sound vibrate and flash; the nixie tube will display CALL and pager No. alternately. If the pager cannot receive the required message in 4 min, it will alert and display OUT to prompt you the pager is out of range.
Setting pagers by transmitter.
1. Pager No. setting
? Input No. to transmitter, then press down arrow key to move cursor to the first location of text area, then press WORDS , then down arrow key again, “Studycapcodes”will be display in text area. Finally, waiting coaster pager is on setting status, press SEND to finish No. setting.
? In 10 S after pager leave recharge base, press key on the bottom case, all the alert led will be on, the nixie tube display will be disappear, that shows pager is in study status. If got right message in 1 min , the pager will finished No. setting and show the No., otherwise it will quit setting status and working with the old No..
2. Other function setting (Please do not using these functions if not family)
The transmitter can setting functions of the pagers on recharge base.
Working ways: Move the cursor to first location of text erea, press words key,then down key, the first display is STUDYCAPCODE, continue to press down key, follow will display in turn:
SET OUT OF RANGE ENABLE
SET OUT OF RANGE DISABLE
SET FLASH LED ENABLE
SET FLASH LED DISABLE
SET BEEP ENABLE
SET BEEP DISABLE
SET VIBRATE ENABLE
SET VIBRATE DISABLE
SET REMIND VOICE ENABLE
SET REMIND VOICE DISABLE
SET ALERT LENTH
SET RESET BY CHARGER
SET RESET NO CHARGER
If you want to active one function, press SEND when the function display, the pagers on recharge base will display SET 3S, show the functions had been active.
Attention: You need to input 2 bit second time on No. area first when you want to using SET ALERT LENTH function.